Catskill-craftsmen 1448 Manuel d'utilisateur

CRAFTSMEN, INC.Assembly Instructions Model 1448Model 1448A. Assembly uses the Bastion System; a simple yet rugged compression fastening system.B. Th

STEP 8Assemble DrawersA. Attach the Drawer Back to the Left and Right Drawer Sides with four 1 ¼”#8 Screws. Make sure the slots that run the length of

Illustration 8CDrawer Front D. Insert the B-Nuts into the nut access holes on the inside of the Drawer Sides with the threaded end facing out. Take th

11STEP 9ATTACH TOWEL BARSee Illustrations 10 and 11. Screw Nickel Plated Towel Bar Posts into the drawer front using 1-1/4” #8 screws. Attach pipe hol

STEP 10INSERT DRAWERA. Align the drawer glides attached to the drawer and the other half of the glides attached to the glide support braces. Slide the

BUTCHER BLOCK OIL COUPON For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. If

P/N: TT1448B(1) Table Top 48” x 24” x 2”P/N: SLS1448B(2) Slated Shelf 43-3/4” x 18” x 1-3/4”P/N: DF1448B(1) Drawer Front 39-3/8” x 5-3/8” x 3/4”P/N:

P/N: L-bracket1448B(4) L-Brackets(10)(10)(10)P/N: Leveler1448(4) 7/8 LevelerP/N: Pipe1448B(1) Nickel Plated Towel Bar Handle32” x 5/8”P/N: EndCap1448B

Bastion AssemblyINSTRUCTIONS FOR BASTIONS3ILLUSTRATION ONLY. See Steps 1 & 3 for bastion placement for this unit.

4STEP 1ASSEMBLE SIDE PANELSA. Each side panel consists of two (2) legs, one (1) top side brace and one (1) glide support brace. When assembled, diagon

PREPARE SIDE ASSEMBLIES FOR BACK BRACESThe Top Back Brace utilizes the Bastion system for attachment. Place the Bastion posts into their positions on

STEP 3ATTACH BACK BRACEA. You may find it easiest to attach the back brace and shelves by inverting the island. Attach the back brace with bastions to

7STEP 5TABLE TOP PREPARATION & ATTACHINGAttach four (4) “L” brackets (using 5/8” #6 screws) to the bottom side of the table top. Note the proper p

STEP 7INSERT LEVELER FEETA. Hammer the threaded T-bolt into the predrilled hole on the bottom of each leg. Screw the leveler into the T-bolt. Height o